UFactory 850 - 850 User Manual Software Section; UFactory Studio; Terms and Definitions; Appendix

7
(2) Electrical interface
(3) 850 end-effector
850 User Manual Software Section
(1) UFactory studio instructions
(2) 850 motion analysis
(3) Typical examples
Appendix
(1) 850 error reporting and handling
(2) 850 technical specifications
(3) FAQ
(4) The 850 software/firmware update method
(5) Maintenance and Inspection
(6) After-sales service
Terms and Definitions
The following terms and definitions apply to this manual.
Control Box
The control box, core part of the robotic arm, is the integration of
the robotic arm control system.
End Effector
The end effector, installed on the front end of the wrist of the
robotic arm, is used to install special tools (such as grippers,
vacuum gripper, etc.), which can directly perform work tasks.
Enable Robotic Arm
Power on the robotic arm and turn on the motor of the robotic arm.
After the robotic arm is enabled, it can start to move normally.
TCP
Tool center point.