22
2.Control box x 1
3.Robotic arm power and signal cable x 1
4.Power cable for the control box x 1
5.Robotic arm end effector adapter cable x1
6.Ethernet cable x1
7.Ethernet adapter cable x1
The 850 robotic arm system consists of a base and rotary joints, and
each joint represents a degree of freedom. From the bottom to the top,
in order, Joint 1, Joint 2, Joint 3, etc. The last joint is known as the tool
side and can be used to connect end-effector (e. g. gripper, vacuum
gripper, etc).
Refer to technical specifications for joint Figures（See appendix-2）.
To Next Page
Loading...
