33
10. 5 DISASSEMBLING THE DEFROSTING FAN AND THE LID PRESENCE SENSORS
1 Remove the air conveyor by pressing on either side. Pull the defrosting fan out of its seat in the conveyor. The lid presence
detectors are situated at the rear of the conveyor and can be removed from their seat with the help of a small screwdriver.
10. 6 DISASSEMBLING THE TEMPERATURE SENSOR
1 The temperature sensor is situated inside the front evaporator cylinder cap. To replace it, first loosen the fastening nuts, then,
with the help of a rubber hammer, push the tie rods and then pull the front cap out.
2 Lastly, loosen the temperature sensor fastening screw situated inside the cap. If necessary, pull out the mixer drive shaft from
its seat.
11 UPDATING THE FIRMWARE
The dispenser firmware can be updated by uploading the correct update files to the circuit board memory. Each board, control board,
master power board and slave power board has its own firmware which can be updated individually. To do this, you need the special
programmer supplied by the manufacturer shown in the figure below. This is supplied with an adapter which is used or not according
To Next Page
Loading...
