UNI-T UTD2025 series User Manual

Uni
-
Trend Technology (Chengdu) Ltd
.
Page
22
of
27
Communica
tion & Control So
ftware for
UTD20
25
_30
25
Series Oscilloscopes
User
Manual
5.
Enter the “transmission int
erface” and click the [Transmission Interface] button. The indicator light comes
ON. Transmission interface mode is now enabled, as shows in Fig 3
-
4.
Fig 3
-
4
6.
On the virtual control panel in Fig 3
-
4, you can oper
ate your oscilloscope with different buttons as instructed
by the oscilloscope user manual. Select “Serial” on the above screen so the oscilloscope can transmit the
oscilloscope screen to the virtual display panel in real time. When “Single” is selected, t
he virtual display
panel will only show the first transmission interface.
Note :
In serial mode when transmission volume is high, response of the software is relatively slow. In single
mode, however, response is quick as there is only one transmission and
data volume is low.
7.
When operation is complete press [CLOSE] to close this screen.
Note :
The “data transmission”, “remote control” and “transmission interface” functions cannot be operated
simultaneously.

UNI-T UTD2025 series Specifications

General

Brand	UNI-T
Model	UTD2025 series
Category	Test Equipment
Language	English