UNI-T UTD2025 series - Page 6

Uni
-
Trend Technology (Chengdu) Ltd
.
Page
6
of
27
Communica
tion & Control So
ftware for
UTD20
25
_30
25
Series Oscilloscopes
User
Manual
Fig
1
-
6
Step seven :
When automatic installation is complete and the box shown in Fig 1
-
7 pops up, click the
[FINISH (
F
)] button. Your oscilloscope communication and control software is now
successfully installed on your computer and ready for use.
Fig 1
-
7
To return to the previous installation guide interface, click [BACK (
B
)] on any installation guide page.
To stop installation, press [CANCEL (
C
)] on any installation guide page.