UTD2000 Series User Manual
46
11.3 Help Menu
Press the HELP key to into help menu，then press any key will display the help
information of this key.
11.4 Upgrade program
TheUSBupgrade program makes upgrade easier and more flexible. To use this
function followthe steps below:
(1) Check themodel name, software and hardware versions of your oscilloscopein
Table 2-19.
(2) Download the highest version of the update program document that matches your
model, software and hardware versions online, and store it on the USB device (preferably
a USB device recommended by us).
(3) Power off the oscilloscope then insert the USB device. Then power on the
oscilloscope again. The prompt Please press F5 to continue or F1 to cancel appears on
the screen as shown in the figure on theright
Figure 11-2 USB update confirmation
(4) When F5 is pressed,
the prompt on the right will appear: “Are you sure you wish to
update? If yes, press F5, otherwise press F1 to cancel upgrade”.
(5) When the USB document is confirmed the following prompt will appear : “System
upgrade is in progress. Please wait”. (This process may take 3 to 5 minutes)
To Next Page
Loading...
Need help?
General
