UNI-T UTD2102CEX - Chapter IX Storage and Load System; Setup Storage and Load; Waveform Storage and Load

UTD2000 Series User Manual
39
Chapter IX Storage and Load System
User can enter the storage and load menu by pressing the STORAGE button.
Figure 9-1 Function Key of STORAGE
Press STORAGE to go to the type menu. There are three types to choose from:
Setup,Wave and Bitmap
9.1 Setup storage and load
Press the Storage button, then Press F1 to choose storege type Setup , and you will
see the following menu.
Table 9-1 Setup storage menu
Function Menu Setting Description
Type Setup Select to store a DSO setting
Dest
1~20
Maximum 20 front panel setups can be storedwith themultifunction control knobon the
front panel
1~200
Set the waveform storage position on the USB device (This function can be enabled
only when theUSB device is plugged in and the disk menu is set to“USB”)
Save —— Store waveform
Load
Recall the setting
9.2 Waveform storage and load
Press the Storage button, then Press F1 to choose storege type Wave , and you will
see the following menu.
Table 9-2 Waveform storage menu (Page 1)
Function Menu Setting Description
Type Wave Select to store a acquired waveform
Source
CH1 Select waveforms from CH1 channel to be saved
CH2 Select waveforms from CH2 channel to be saved
Dest
1~20
Maximum 20 front panel setups can be storedwith themultifunction control knobon the
front panel
1~200
Set the waveform storage position on the USB device (This function can be enabled
only when theUSB device is plugged in and the disk menu is set to“USB”)
Save —— Store waveform
Next 1/2 Get to the next page