99
WHEEL AND TIRE
WARNING
!
• OSHA safety procedures must always be followed. Refer to
OSHA 1910.177.
• Only properly trained personnel should replace pneumatic
tires on multi-piece rim sets.
• Always use correct procedures when servicing or replacing
pneumatic tires on multi-piece rim sets.
• When inating or deating tires, a suitable safety cage or
barrier shall be used.
• Failure to use proper procedures can cause explosive
separation of tire and rim set, death or serious injury could
result.
• If any of these warning are not adhered to it could result in
death or serious injury.
• Tires used on lift trucks manufactured in Japan and the U.S.
are different. Do not mix different sizes or tire types, as this
could affect stability.
• If the tire pressure is not correct it can affect the stability of
the lift truck, potentially resulting in a tip-over. It can also
cause rupturing, premature tire wear or explosive separation
of the multi-piece rim set.
• When checking the tire pressure, do not face the tire side to
avoid a danger because the tire pressure is very high.
To Next Page
Loading...
