UniCarriers 1F1 - Removing Cylinder (Tank) Fixed Type; Installing Cylinder (Tank) Fixed Type; Refilling LPG Cylinders (Tanks)

117
2. Follow steps 2 through 4 in installing cylinder swing-out type (refer
to page 115-116).
3. While supporting the bottom of the LPG cylinder, slowly push the
holder up until it is in a horizontal position.
4. Follow step 5 through 8 in installing cylinder swing-out type (refer
to page 116).
5. Ensure hose is in clip and attached to radiator cover.
Removing Cylinder (Tank) Fixed Type
Follow steps 1 through 5, 8 & 9 in removing cylinder swing-out type
(refer to pages 114-115).
Installing Cylinder (Tank) Fixed Type
Follow steps 1 through 4 and 6 through 8 in installing cylinder swing-
out type (refer to pages 115-116).
REFILLING LPG CYLINDERS (TANKS)
WARNING
!
• Only a trained and authorized person should rell LPG
Cylinders (tanks).
• Do not rell cylinders (tanks) while mounted on a lift truck.
• Make sure that you know and understand the proper
procedure for lling a LPG Cylinder (tank).
• Know all local re codes.
• If you have any questions about relling LPG Cylinders
(tanks)., please ask your supervisor.
• If problems with lling occur, call your LPG supplier.
The weight scale method to ll the cylinder (tank) is highly
recommended to protect the environment and to reduce re hazards.
This method will reduce overlling and the discharge of LPG into the
environment.
• Store full and empty cylinders (tanks) according to local re codes.
• When lling LPG Cylinder (tank), always observe the local laws and
regulations.