Basic Operation
Switch the Handset On and Off
Basic Operation
The following chapter describes how to use the basic functions of the WL4 handset. It is recom-
mended to read this section when using the handset for the first time.
This chapter includes the following sections:
• Switch the Handset On and Off on page 16
• Turn the Signals Off or On on page 16
• Lock and Unlock the Keypad on page 17
• Use the Auto Phone Lock on page 17
• Use the Handset as a Shared Phone on page 17
Switch the Handset On and Off
Switch On the Handset
When switched off, press and hold the On/Off key until the handset vibrates and the dis-
play lights up.
Switch Off the Handset
NOTICE: The handset can be configured to automatically switch off when placed
in charger. It is also possible to configure the handset to prevent the user from
switching it off. For the details, please refer to the Configuration Manual, Unify
OpenScape WLAN Phone WL4.
1)
In Idle mode, press and hold the On/Off key .
2) The dialog window Switch off? is displayed. Confirm by pressing Yes.
Turn the Signals Off or On
NOTICE: The handset can be configured to not allow the user to mute the hand-
set or set the volume below a certain level. For the details, please refer to the
Configuration Manual, Unify OpenScape WLAN Phone WL4.
There are two different methods to turn off/on ringtones and notification sounds:
•
In Idle mode, press and hold the Sound off key or the Mute button. The Sound off
icon appears in the Status bar to show that the handset has been muted. Press and hold
the Sound off key or the Mute button again to turn the signals on.
• In Idle mode, press the Volume down button. Press and hold the button again until the
handset enters the silent mode. The Silent volume icon appears in the Status bar to
show that the handset has been muted. Press the Volume up button two times to unmute
the handset.
A31003-M2000-U109-01-7619, 29/04/2020
16 OpenScape WLAN Phone WL4, User Manual
To Next Page
Loading...
Need help?
General