A D V A N C E D CALLING
•
25
Clearing conversations
If you do not want to leave a conversation in memory, you can
erase the conversation memory. This erases all conversations,
but does not erase auto-answer memory. Follow these steps:
1. Press the key.
2. Press the key to select CLEAR.
3. Press the key to select CONVERSATION.
4. Press the key when the display says CLEAR CONV
MEMORY Y/N. Press any other key if you decide not to clear.
About Auto ID
™
The Auto ID
™
alert system tells a hearing person or an emer-
gency service that you are calling by text telephone. It only
works in text-telephone mode. As soon as you dial a number,
Auto ID sends several tones over the telephone line every few
seconds. It stops when someone starts typing. When Auto ID is
on, you will see SENDING ID on the display.
Auto ID also comes on during a conversation if no one types for
a few minutes. It continues until you type or receive characters.
You can turn off Auto ID by following these steps:
1. Press the key.
2. Press the key to display the Options menu.
3. Press the left key, the right key, and the key all
at the same time to display the Options 2 menu.
4. Press the key to select AUTO ID.
5. Press the key. You will see AUTO ID OFF.
6. Press the key to leave the Options 2 menu.
Follow the same steps to turn on Auto ID again.
Menu
ShiftShift
O
Menu
Y
C
Menu
To Next Page