30
•
VCO CALLING
Answering a VCO call
Answering a VCO call is the same as answering a text call.
After the conversation has begun, do the following:
1. Tell the other person you want to use VCO.
2. Pick up the handset. You see CCITT VCO–MENU THEN V
on the display screen.
3.
Press
+ to turn on VCO. You see VOICE MODE
PRESS SPACE FOR TEXT on the display screen.
4. When you are finished speaking, press the to recon-
nect into text mode. You do not need to replace the handset.
5.
Repeat steps 3-4 until your conversation is finished.
6.
When the conversation is finished, hang up the handset and
then hold down either key and press the key.
Note: After you pick up the handset, you may see this display
screen:
This display screen means your call connected using Baudot,
EDTN, or Turbo Code. You do not need to press + each
time you want to speak. Begin speaking when you see this dis-
play screen.
Using hearing carry-over (HCO)
For people who can hear but do not wish to speak, the
Uniphone 1150 can make HCO (hearing carry-over) calls. HCO
is the opposite of VCO. You type to the other person and listen
to the other person’s reply. Follow the VCO procedures on
pages 28-29.
VMenu
To Next Page