CARE AND REPAIR
•
47
8
CARE &
REPAIR
Problem solving
The display shows all numbers and punctuation marks instead
of words.
Press the . The text should change to words.
The Uniphone 1150 does not turn on when I press the
key, or the Off-hook light blinks, even when the AC adapter is
plugged in.
Be sure the AC adapter is firmly plugged in and the electrical
point is working. If this does not solve the problem, the AC
adapter or the Uniphone 1150 may have a problem. Contact
your dealer or Teletec International Ltd.
The display on my Uniphone 1150 is blank, even though the
machine is plugged in.
Try pressing the key or pick up the handset. The first
time you plug in the Uniphone 1150, you must do this to turn
on the display. You also have to do it after a power failure if you
have not installed a battery. Also, make sure that the electrical
point is turned on and working.
My Uniphone 1150 does not ring when I get a call.
Be sure the ringer switch on the back of the Uniphone 1150 is
set to ON.
TTY On/Off
TTY On/Off
Spacebar
CHAPTER
To Next Page