CODES • 43
CCITT settings and computer connections
If you use CCITT code often, you may need to change settings.
You can change the following settings on your Uniphone 1150
before or during your call:
Originate/Answer determines which machine is calling (originat-
ing) and which machine is answering. The default is originate.
Duplex controls how characters are displayed. If you get double
characters (lliikkee tthhiiss) or none at all, change the setting
from full duplex to half duplex. The default is half.
Parity controls how your Uniphone 1150 checks for errors. You
can choose 8N1 or 7E1. The default is 8N1.
Return (CR) determines what the Uniphone 1150 sends when
you press the key. You can choose CR or CR+LF. CR (car-
riage return) goes to the beginning of the current line. CR+LF
(carriage return plus line feed) goes to the beginning of the
next line. The default is CR.
Seek Time determines how many seconds the Uniphone 1150
tries to connect in CCITT before it tries to connect in Baudot or
Turbo Code. You can choose 2 through 9 seconds. The default is
3 seconds.
To Next Page