Packing
Packing steps:
1) Hang the G1 robot vertically and prepare the matching transport box..
2) Lift the big and small legs of the G1 robot, fold them back until the waist is level, please pay attention
to the direction.
3) Slowly lower the suspension rope so that the G1 robot's rear end enters the transport box first and
moves to the corresponding side of the transport box..
4) Place G1 with its head and chest facing down, lying flat in the box, paying attention to the direction.
5) Place the robot arms on both sides of the body, and rotate the wrists vertically to ensure they can fit
into the box.
6) Fold your legs back towards your body and place them inside the box, ensuring that the soles of your
feet and calves fit snugly against the lining.
7) Make sure to buffer the collision of each contact surface of the robot, put in relevant accessories such
as remote control, charger, etc., complete the packing, and be careful not to miss the square lining placed in
the middle of G1.
To Next Page
Loading...
