Requiring Environment
1) Run the robot in 0°C -40°C with good weather condition. Do not run in inclement weather, such as
fog, snow, rain, lightning, sandstorms, windstorms, tornado weather, etc.The robot is not waterproof, so do
not run it with water on the ground, in rain, snow, or wet conditions! The robot is not dustproof, please do not
run it on gravel floors, dusty environments!
2) When using the robot, keep it within your field of vision and a safe distance of at least 2 meters from
obstacles, complex terrain, crowds, water and other objects.
3) Please do not run the robot in an electromagnetic interference environment. Sources of electromagnetic
interference include but are not limited to: high-voltage power lines, high-voltage transmission stations,
mobile phone base stations, and television broadcast towers.
4) Please do not run the robot in the Wi-Fi signal interference environment. Wi-Fi signal interference is
usually caused by co-channel interference. In case of interference, be sure to turn off some or all Wi-Fi signal
sources of other wireless devices before using the remote control to operate the robot.
5) Due to the varying levels of proficiency among actual operators, for reliability and safety, please use
the robot in an open, flat, and unobstructed environment. If the robot needs to travel on complex terrain or
terrain with certain ups and downs and slopes, the operator should reduce the robot's walking speed and
carefully control it to avoid tripping over obstacles.
6) The robot has certain requirements for the ground on which it walks. Do not use the robot on very low
friction ground, such as ice. Do not use the robot on soft ground, such as thick spongy ground. If the robot is
used on smooth ground, such as glass and ceramic tile, the users need to control the robot for movement
carefully and smoothly, avoid violent movement, and reduce the walking speed of the robot to prevent the
robot foot from slipping and falling.
Unpacking
Place the box on a flat surface according to the placement requirements (with the front side up), then open
the top of the box and lift the robot out in its entirety. Remove the robot, the remote control, the charger, etc.
from the box separately, place the robot flat on the flat surface, and then prepare to power it on.
Check before Power on
1) Only Use Unitree Robotics authentic parts and ensure that all parts are in good working condition.
2) Ensure that the firmware has been updated to the latest version.
To Next Page
Loading...
