Hanging and turning on
1) Preparation before startup
Please place G1 steadily on the ground, thread the rope through the special suspension buckles on both
shoulders, and securely tie it to the dead knot. Hang the rope onto the suspension buckle of the protective
frame, gradually raise G1 by adjusting the support, ensuring that the robot's body is completely suspended and
its feet do not touch the ground.
2) Installing Battery Packs
Insert two batteries into the battery compartment from the side of the robot, paying attention to the
installation direction. The power switch should face the back of the robot. If it is not possible to fully insert
the battery pack, please adjust the direction of the battery pack and do not forcefully press it to avoid damaging
the battery interface and buckle. When you hear a "click~" sound, the battery pack installation is completed.
Please ensure that the buckle is in place!
To Next Page
Loading...
