© 2024 All rights reserved, Unitree Robotics 7
5) In the charging state, the battery indicator of battery pack will flash at a frequency of 1Hz (1
second/time) and indicate the current battery.
6) If the battery indicator is off, the battery pack is fully charged. Please remove the battery pack and
charger to finish charging.
7) The temperature of the battery pack may be high after running, t, and the battery pack must be charged
after the temperature of the battery pack has dropped to room temperature.
⚫ It is strictly prohibited to use unofficial chargers to charge G1 batteries. Please use official chargers for
charging!
Remote Control Charging
When the battery indicator light of the companion remote control shows that the battery is low, you should
connect the companion remote control to the charger as shown in the figure below:
1) We recommend you to use a 5V/2A USB charger which meets FCC/CE standard.
2) Ensure that handheld remote control is switched off before charging it.
3) The power indicator light will flash at 1Hz (1 second/time) in charging status and indicate the current
power level.
4) When the power indicator light is all off it means the battery pack is full, please remove the charger to
finish charging.
To Next Page
Loading...
