3) The users ensures that he or she is not operating the robot while intoxicated, under the influence of
drugs, and unable to concentrate.
4) Be familiar with the characteristics of each gait mode. Be familiar with the emergency braking method
of the robot in case of instability / loss of control.
5) Ensure that there are no foreign matters (such as water, oil, sand, soil, etc.) inside the robot and its
components.
6) Ensure that the remote control module and battery pack are fully charged.
7) Check whether the protective bracket is installed correctly and whether the bottom universal wheel is
locked.
Sitting upright and turning on the device
1) Preparation before startup
If conditions permit, G1 also supports booting while sitting in a chair.First, ensure that the G1 is sitting
on a chair with arms and legs placed naturally, as shown in the following image.
2) Installing Battery Packs
Insert two batteries into the battery compartment from the side of the robot, paying attention to the
installation direction. The power switch should face the back of the robot. If it is not possible to fully insert
the battery pack, please adjust the direction of the battery pack and do not forcefully press it to avoid damaging
the battery interface and buckle. When you hear a "click~" sound, the battery pack installation is completed.
Please ensure that the buckle is in place!
To Next Page
Loading...
