Unitronics Vision 120 OPLC - Function Block and Password Settings; Hardware Configuration Status

To Next Page

To Previous Page

Chapter 6: Information Mode

Category Subject Possible Actions

Function Block

FBs in use

• Shows a list of all function blocks that

have been downloaded into the

controller.

Both the FB name and its version are

displayed.

Password

New

• Set a New Password

Hardware

Configuration

• Check if I/O Expansion Modules are

installed.

Note that I/O Expansion Modules are

represented by letters. Identical

module types are represented by

identical letters as shown below.

• Shows if an on-board I/O or I/O module

is short-circuited.