6.6 Attach to table stand
The illustration below shows how to attach the
thermostat to a table stand.
1
3
2
4
6.7 First startup of digital thermostats
At first startup, before registering, the thermostat
requires some basic settings.
See section 12 Operate Uponor Smatrix Wave/Wave
PLUS digital thermostats for more information.
Software version
Current software version is displayed during power up.
T-167
T-168
Set time (T-168 only)
When starting the thermostat for the first time, after a
factory reset, or after its been left without batteries too
long, the software requires the time and date to be set.
This setting is required to utilise scheduling programs
for this thermostat.
Use buttons - or + to change the value, press the OK
button to set the value and move to the next editable
value.
NOTE!
If no button is pressed for about 8 seconds,
the current values will be saved and the
software exits to control mode.
1. Set hours.
2. Set minutes.
3. Set 12h or 24h display of time.
4. Set day of the week (1 = Monday, 7 = Sunday).
5. Set day of the month.
6. Set month.
7. Set year.
8. Press OK to return to run mode.
Date and time can also be set in the settings menu.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
39
UPONOR SMATRIX WAVE/WAVE PLUS
· INSTALLATION AND OPERATION MANUAL
To Next Page
Loading...
Need help?
General
