2
3
3 4
T-166
T-167
T-168
T-165
T-163
5 s
5 s
5 s
5
7
2
5
6
3 s
To register room thermostats in the controller:
1. Press and hold the OK button on the controller
until the LED for channel 1 (or the first unregistered
channel) flashes red.
2. Use buttons < or > to move the pointer (LED flashes
red) to a preferred channel.
3. Press the OK button to select the channel for
registration. The LED for the selected channel starts
flashing green.
4. Repeat steps 2 and 3 until all channels to be
registered with the thermostat are selected (LEDs
flashing green).
Note! It is recommended to register all channels to
the thermostat at the same time.
5. Thermostat T-163
5.1 Gently press and hold the registration button
on the thermostat, release when the LED starts
flashing green (located in the hole above the
registration button).
The selected channel LED in the controller turns
fixed green and the registration is complete.
Thermostat T-165
5.1 Gently press and hold the registration button
on the thermostat, release when the LED on the
front of the thermostat starts flashing.
The selected channel LED in the controller turns
fixed green and the registration is complete.
Thermostats T-166, T-167 and T-168
5.1 Press and hold both - and + buttons on the
thermostat until the text CnF (configure) and a
communication icon is displayed.
The selected channel LED in the controller turns
fixed green and the registration is complete.
6. Repeat steps 2 through 5 until all used room
thermostats are registered.
7. Press and hold the OK button on the controller
until the green LEDs turn off to end registration and
return to run mode.
To unregister already registered thermostats, see section
10.6 Unregister channels in controller.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
41
UPONOR SMATRIX WAVE/WAVE PLUS
· INSTALLATION AND OPERATION MANUAL