Uponor Smatrix Wave User Manual

2 = Relay module
See section 5 Install Uponor Smatrix Wave/Wave
PLUS controller for more information.
3 = Public thermostat with outdoor sensor.
4 = Public thermostat with heating/cooling switch
from contact or, in a Wave PLUS system only,
heating cooling switch from sensor input.
5 = Public thermostat with Comfort/ECO switch
from contact
5. Press the OK button to select system device
channel. The channel LED starts flashing green.
6. Public thermostat T-163 as a system device
6.1 Gently press and hold the registration button
on the thermostat, release when the LED starts
flashing green (located in the hole above the
registration button).
The selected channel LED in the controller turns
fixed green and the registration is complete.
7. Repeat steps 4 through 6 until all system devices
are registered.
8. Press and hold the OK button on the controller
until the green LEDs turn off to end registration and
return to run mode.
To unregister already registered sensors and switches,
see section 10.6 Unregister channels in controller.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
43
UPONOR SMATRIX WAVE/WAVE PLUS · INSTALLATION AND OPERATION MANUAL

Uponor Smatrix Wave Specifications

General

Brand	Uponor
Model	Smatrix Wave
Category	Floor Heating Systems
Language	English