Uponor Smatrix Wave User Manual

To enter the settings menu:
1. Press and hold the OK button for about 3 seconds.
2. The settings icon and menu numbers is displayed in
the top right corner of the display.
3. Use buttons - or + to change the numbers to locate
a submenu (see list below) and press OK.
00 = Program (T-168 only)
02 = Heating/cooling changeover*
03 = ECO mode setback temperature
04 = Control mode
05 = High floor temperature limitation
06 = Low floor temperature limitation
07 = Cooling allowed
08 = Display unit
09 = Climatic controller integration
10 = Time and date (T-168 only)
* This menu is not visible if the thermostat is
registered to a controller.
4. Change parameters in the submenus.
5. Press and hold the OK button for about 3 seconds
to exit the settings menu.
00 Program (T-168 only)
In this menu, one of seven different scheduling
programs for Comfort/ECO mode can be set.
Program 1 to 6 is pre-programmed and the 7th is user
programmable.
This menu is not visible if an interface is connected to
the system. Settings are referred to an interface (Wave
PLUS only).
Program Off (default):
Room is set in Comfort mode. If a timer is available
in the system, the room will use those set schedules
but the thermostats own ECO mode setback
temperature.
Program P1:
Program P2:
Program P3:
Program P4:
Program P5:
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
62
UPONOR SMATRIX WAVE/WAVE PLUS · INSTALLATION AND OPERATION MANUAL

Uponor Smatrix Wave Specifications

General

Control	Wireless
Communication	RF 868 MHz
User Interface	Touchscreen
Range	Up to 30m in open space
Battery Life	Thermostat battery life up to 2 years
Operating Temperature	0°C to +40°C