Uponor SmatrixMove User Manual

8. Thermostat T-166, T-167 and T-168
8.1 Press and hold the OK button on the
thermostat for about 5 seconds to enter the
settings menu. The settings icon and menu
numbers are displayed in the top right corner of
the display.
8.2 Use buttons - or + to change the numbers to 04
and press OK. Current control mode is displayed
(RT, RFT, RS or RO).
8.3. Use buttons - or + to change control mode to
RO and press OK.
8.4 Use buttons - or + to change the numbers to
09 and press OK. The text Int YES is displayed,
if the thermostat already is registered as a
reference room thermostat.
8.5. Use buttons - or + to change Int no to Int
CNF.
8.6. The connection indicator starts flashing in the
thermostat display to show that the registration
process begins.
8.7 The current outdoor temperature is shown in
the controller display, and the text Int YES
is shown in the thermostat display when the
registration is complete.
8.8 Press and hold the OK button on the
thermostat for about 5 seconds to exit the
settings menu, or wait about 70 seconds for the
software to exit itself.
Thermostat T-163
8.1 Make sure the DIP switch is set correctly.
8.2 Gently press and hold the registration button
on the thermostat, release when the LED starts
flashing green (located in the hole above the
registration button).
8.3 The current outdoor temperature is shown in
the controller display when the registration
is complete. It might take some time for the
thermostat to send the current temperature
data to the controller. 00.0 is displayed in the
meantime.
9. Press the OK button on the controller to confirm
the change and return to the system parameter
settings.
10. Use buttons < or > to locate parameter 24 (End)
– Exit system parameter settings.
11. Press the OK button to exit the system parameters
menu.
To unregister already registered thermostats and/or
sensors, perform a factory reset on both the controller
and thermostats.
See section 8.6 System parameter settings > 23 –
Factory reset for more information about the controller.
See section 9.4 Factory reset, for more information
about analogue thermostats.
See section 10.11 Factory reset, for more information
about digital thermostats.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
35
UPONOR SMATRIX MOVE/MOVE PLUS · INSTALLATION AND OPERATION MANUAL

Uponor SmatrixMove Specifications

General

Brand	Uponor
Model	SmatrixMove
Category	Temperature Controller
Language	English