EasyManua.ls Logo

Upright X Series - Operation; Platform Extension; Travel With Platform Lowered

Upright X Series
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 Translation of the original instruction”
B-11 Check the oil level in the drive hub......................................
......34
B-12 Replace the hydraulic tank return filter....................................
......34
B-13 Check that the brake structure is correct..........................................
......35
Check table C program
C-1 Test platform overload pressure sensor and platform height sensor (if
equipped)........
......36
Check table D program
D-1 Check the chassis slider and the platform slider....................................
......39
D-2 Replace the hydraulic filter............................................
......39
D-3 Replace the wheel oil............................................
......40
D-4 Test function pump................................................
......41
Check table E program
E-1 Test or replace hydraulic oil..........................................
......42
E-2 Apply grease to steering shaft and wheel bearings................................
......43
Repair procedures
Platform controller
1-1 Method of removing the platform controller circuit board ................................
......46
1-2 Method of removing the handle........................................
......47
1-3 Method of removing the platform control alarm..................................
......47
1-4 Method of removing the platform controller emergency stop
button..........................
......48
Platform components
2-1 Method of removing the platform............................................
......49
2-2 Method of removing the platform extension board....................................
......50
Scissor arm components
3-1 Method of removing scissor arm parts (take 80W as an
example)............................
......52
3-1 Method of removing scissor arm parts (take 100W as an
example)...........................
......56
3-3 Method of replacing the pad............................................
......58
3-3 Lifting cylinder..................................................
......59
Chassis components
4-1 Hydraulic pump....................................................
......61
4-2 Hydraulic tank..................................................
......62

Table of Contents

Other manuals for Upright X Series

Related product manuals