USAutomatic SENTRY 300 S - Page 24

23
Programming Transmitter and Receiver (cont)
2. Pressandholdtherighttransmitterbuttondown.
Redlightontransmittershouldbeon.
3. PresstheP2push-buttonuntilthegreenLDlightcomeson.
4. Releasebothbuttons.Transmitterrightbuttontoreceiverprogrammingiscomplete.
Receiver Programming - Latch Open Mode:RelayP2programmingfrommomentarytolatchingmode
(toholdgateopen)
1. PresstheP2push-buttonuntilthegreenLDlightcomeson,thenrelease.GreenLDlight
should be steady.
2. WhilethegreenLDlightison,pushtheP1push-buttondownandrelease.GreenLDlight
shouldbeashing.Latchingmodeisset.
Verifying Receiver P2 relay is programmed to latching mode:
1. PresstheP2push-buttonuntilthegreenLDlightcomeson,thenrelease.
2. GreenLDlightshouldbeashing.IfgreenLDlightissteady,redotheReceiverProgramming
sectionabove.
Resetting receiver P2 relay to momentary mode:
1. PresstheP2push-buttonuntilthegreenLDlightcomeson,thenrelease.
GreenLDlightshouldbeashing.
2. WhiletheLDlightisashing,pushtheP1push-buttondownandrelease.
GreenLDlightshouldbesteady.Momentarymodeisset.
Erasing Single Transmitter from Receiver Memory:
Thedipswitchsettingsofthetransmittertobedeletedmustbeknown.Ifknownfollowthestepsbelow.
1. Setthedipswitchesinatransmittertomatchtheswitchsettingsofthetransmittercodetodelete.
2. Press and hold the left transmitter button.
3. Onthereceiver,pushtheP1push-buttonuntilthegreenLEDlightcomeson.Thenreleaseboth.
4. Ifrightbuttonwasprogrammeditmustbedeletedalso.Pressandholdtherighttransmitterbutton.
5. Onthereceiver,pushtheP2push-buttonuntilthegreenLEDlightcomeson.Thenreleaseboth.
6. Transmitterisnowerasedfromreceivermemory.
Erasing all Transmitters from Receiver Memory:
1. PresstheP2buttononthereceiveruntilthegreenLDlightcomeson.ThenreleaseP2button.
2. WhileLDlightisonpresstheP1andP2buttonssimultaneouslyandholduntilthegreenLDlight
beginstoblinkslowly.Itshouldblink4timesthenalltransmittercodesareerased.