Preparations
2-3
4
Grasp the paper length adjusting tab and adjust the
length guide to the paper size.
Important! • Make sure that the length guide is flush against
the paper. If there is space between the guide and
the paper, set the length guide again.
• When setting 11 × 17" (Ledger) paper, move the
paper length guide to the right end and push it
down as shown in the illustration.
Note The paper sizes are impressed in the cassette.
5
Set the paper straight from the upper part.
Important! • Be careful not to bend or crease the paper when
inserting it into the cassette. Creases in the paper
may lead to paper jams.
• The maximum paper limit indicator A is provided
on a paper width guide. Make sure that the paper
loaded is below the maximum paper limit indicator.
• When loading paper into the cassette, set it with
the side which faced the top of its packaging
facing up.
• Be sure to adjust the width and length guides to
the paper size before loading the paper. Failure to do so may result in paper skewing or
jamming.
• If the length and width guides are not flush against the paper, a size that is different from the
actual size may be displayed on the message display.
• When the paper has become wrinkled from moisture and cannot be fed, set the paper so that
the wrinkled side is toward the length guide.
A
To Next Page
Loading...
Need help?
General
