Optional Equipment
4-9
2
Remove the staple jammed at the end (side on which
staples are set).
3
Lower the face plate of the staple holder to its original
position.
4
Insert the staple holder into the insertion slot as it was. Insert it completely until it clicks.
5
Close the stapler front cover.
Job Separator
This unit is used to separate paper output destinations
for easy classification. Copies are output to the output
tray, and printer output is ejected onto the job separator
tray. Also the output destinations can be specified.
On the front side of the machine, a paper indicator is
provided for showing that there is paper on the job
separator tray.
Important! • Note that a paper jam may occur at the output section due to paper curling depending on the
paper type.
• If finished papers come out curled or are stacked unevenly, turn the paper in the cassette over
and set it again.
Notes • To output paper onto the job separator, change the
setting in the machine default settings (copier) or
the paper settings (printer).
• When removing paper from the job separator tray,
pull it at an angle so that any corner of the paper is
not hit.
To Next Page
Loading...
Need help?
General
