->Up/Download
(only in Surface Interval mode) Switching to DFU – Device Firmware Update mode or
Logbook Downloading.
When switching to this mode, the computer will be re-loaded. All the basic settings will
be automatically saved in a non-volatile memory. Upon exiting the mode the computer
will offer you either to reset all the default settings, or to upload the settings saved
before.
NOTE! When switching to this mode your dive computer will be reloaded, and all the
current settings, tissues' saturation, CNS and system time data will be lost!
->Mode
(only in Surface Interval mode) Switching between Technical, Recreational and Gauge
(bottom timer) Modes. For details see Gauge Mode and Recreational Mode.
->Water density
(only in Surface Interval mode) Water Density setting.
Available values 0.900-1.050 with discretion interval of 0.005. This value affects the
accuracy of depth indications with various water salinity level. This setting does not
affect any decompression calculations! All the decompression calculations are
made based on measured pressure and do not depend on water salinity ratio.
->Flip screen
This mode turns the screen picture by 180 degrees.
->Info
(only in Surface Interval mode)
Battery сharging level and unique computer identification number will displayed on the
screen.
ATTENTION!
Date and time are NOT set automatically in the dive computer!
Set date and time before the first dive!
In case if the dive computer is rarely used,
please, check date and time during each charging!
To Next Page
Loading...