Commissioning vacon • 11
24-hour support +358 (0)201 212 575 • Email: vacon@vacon.com
4
Figure 6.Configuration example from EIPScan tool.
4.1 Parameters
4.1.1 Protocol in use
When value is changed to one, protocol stack is activated.
Please notice that if protocol is stopped (for example protocol is set to zero from panel) and com-
munications have been open, it might be that stack cannot be reinitialized during the next few min-
Table 2. Parameters Menu
# Name Default
Range /
Accepted
Values
ID Definition
1
Protocol In Use 0 0…1 2417
d
0 = protocol not in use.
2
Output Instance 21 20, 21, 23,
101, 111,
128, 131
2418
d
See chapter Assembly Instances
Implemented By Vacon® 100
3
Input Instance 71 70, 71, 73,
107, 117,
127, 137
2419
d
See chapter Assembly Instances
Implemented By Vacon® 100
4
Communication Timeout 10 0…65535 2420
d
0 = timeout is defined by the mas-
ter through Requested Packet
Interval (RPI) multiplied by Con-
nection Timeout Multiplier (CTM).
Other value than 0 means the
total time (in seconds) including
the RPI x CTM timeout
To Next Page
Loading...
