Vacon 100 - 5 Programming

5
.
vacon • 14 Programming
Tel. +358 (0) 201 2121 • Fax +358 (0)201 212 205
5. PROGRAMMING
Basic information on how to use the control keypad you will find in the Vacon 100 Drive Appli-
cation Manual (publication DPD00927).
The navigation path to the fieldbus parameters may differ from application to application. The
exemplary paths below apply to the Vacon100 drive.
First ensure that the right fieldbus protocol is selected.
Select
‘Fieldbus control’ as the Remote Control Place.
Choose source of reference.
Set fieldbus parameters (M5.9).
®
Navigate: Main Menu > I/O and Hardware (M5)
Navigate: Main Menu > Quick Setup (M1) > Rem. Ctrl. Place (P1.21)
OR
Navigate: Main Menu > Parameters (M3) > Start/Stop Setup (M3.2) > Rem.
Ctrl. Place (P3.2.1)
Navigate: Main Menu > Parameters (M3) > References (M3.3)