Vacon nxp/c User Manual

9
vacon • 84 CONTROL KEYPAD
Tel. +358 (0) 201 2121 • Fax +358 (0)201 212 205
9.3.6.1 Language selection
The Vacon control keypad offers you the possibility to control the frequency converter through the
keypad in the language of your choice.
Locate the language selection page under the
System menu . Its location indication is S6.1. Press
the
Menu button right once to enter the edit mode. As the name of the language starts to blink you
are able to choose another language for the keypad texts. Confirm the selection by pushing the
Enter button . The blinking stops and all textual information on the keypad is presented in the
language you chose.
You can return to the previous menu anytime by pushing the
Menu button left .
Figure 50. Selection of language
9.3.6.2
Application selection
The user can select the application desired by entering the Application selection page (S6.2) . This
is done by pushing the
Menu button right when on the first page of the System menu . Change then
the application by pushing the
Menu button right once again. The name of the application starts to
blink. Now you can browse through the applications with the
Browser buttons and select another
application with the
Enter button .
Changing application will reset all parameters. After application change, you will be asked if you
want the parameters of the new application to be uploaded to the keypad. If you wish this to happen
push the
Enter button. Pushing any other button leaves the parameters of the previously used
application saved in the keypad. For more information, see Chapter 9.3.6.3.
For more information about the Application Package, see Vacon NX Application Manual.
System Menu
S1

S11
READY
I/Oterm
Language
English
READY
I/Oterm
Language
English
READY
I/Oterm
enter
READY
I/Ot erm
Francais
Langue
11534_uk

Vacon nxp/c Specifications

General

Brand	Vacon
Model	nxp/c
Category	Controller
Language	English