The probe head can be mounted through thin metal walls using the included cable gland or
mounting grommet. Two grommets are included: small one for 6.5 mm diameter hole, and
large one for 12.5 mm diameter hole.
You can also attach the probe head directly using a zip tie. The probe head should be attached
from the point near the black plastic part.
• Temperature measurement range −40 … +120 °C (−40 … +248 °F)
• Operating temperature of probe body −40 … +60 °C (−40 … +140 °F)
• Integrated filter (non-replaceable)
Do not damage the probe head by bending, crushing, or striking it.
Avoid overtightening when installing the probe head through a cable gland.
CAUTION!
More information
‣
Mounting probe head inside DTR502B (page 38)
4.9.1 Installing HMP9 through a cable gland
Figure 14 Installing HMP9 probe head through a cable gland
1
Black plastic part of the HMP9 probe head
2 Nut for tightening the probe in place
3 Base of the cable gland
4 M10×1.5 threads of the cable gland
HMP Series with MMP8 and TMP1 User Guide M212022EN-F
32
To Next Page
Loading...
