Chapter 8 ______________________________________________________________ Maintenance
VAISALA ______________________________________________________________________ 107
To perform the test:
1. Slip the verifier over the three transducers. Refer to Figure 30
below to see how the verifier fits over the transducers.
2. Start wind measurement. The command depends on the selected
communication profile.
3. WMT700 must read less than 0.5 miles per hour (0.22 m/s) with
the verifier in place.
4. Remove the verifier.
NOTE
Some random data samples may be lost during the verifier test. This,
however, does not indicate that WMT700 is faulty.
1005-003
Figure 30 Testing WMT700 with Verifier
To Next Page
Loading...
