USER'S GUIDE____________________________________________________________________
80 __________________________________________________________________ M211095EN-C
POLL — Get Message
This command fetches the latest measurement data from WMT700. You
need to specify the data message format in the command.
NOTE
Vaisala recommends that you only use this command for testing data
connections. To fetch measurement data for other purposes, switch the
serial port to measurement mode. The polling command in the
measurement mode depends on the selected profile.
POLL y
where
y = Identification number for the data message format. For a list
of data message formats, see Table 23 on page 93.
RESET — Reset CPU
This command resets WMT700.
RESET
Information Commands
? — Display Command Set
This command displays a list of available configuration commands.
?
H — Display Help and Messages
This command displays a list of supported data messages and their
identification numbers as well as the available values for wind speed
measurement unit, profile, baud rate, interface, and analog output.
H
To Next Page
Loading...
