Chapter 7 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 91
CHAPTER 7
OPERATION
This chapter contains information on WMT700 operating commands,
protocols and data messages.
Getting Started
After WMT700 has been installed and configured, you can start
operating the wind sensor as follows:
- To receive wind measurement data through a serial connection as data
messages, use serial communication.
When using the WMT700 profile, see the operating instructions in this
section.
When using WS425 or SDI-12 profiles, see the operating instructions
in Upgrading from Vaisala WINDCAP
®
Ultrasonic Wind Sensor
WS425 to WMT700 Technical Reference.
- To receive wind measurement data as current, potentiometer, voltage,
or frequency output, use analog output.
For general information, see Analog Output on page 65.
For instructions on using WMT700 analog output in a system
configured for WS425, see Upgrading from Vaisala WINDCAP
®
Ultrasonic Wind Sensor WS425 to WMT700 Technical Reference.
NOTE
For a complete list of the serial commands available for the WMT700
series wind sensors, see Appendix A, Complete Command Set for
WMT700, on page 121.
To Next Page
Loading...
