Vaisala WMT703 - Installation Procedure; Figure 13 Minimum Distance between Two Wmt700 S Installed at

USER'S GUIDE____________________________________________________________________
38 __________________________________________________________________ M211095EN-C
Figure 13 Minimum Distance between two WMT700s Installed at
Same Height
Installation Procedure
At the measurement site, WMT700 needs to be mounted, aligned, and
connected to the power source and data acquisition system.
You can install the optional bird cage after the wind sensor has been
mounted and the transportation damper has been removed from the
sensor. For instructions, see section Installing Bird Cage on page 50.
CAUTION
When handling WMT700, do not rotate, pull, strike, bend, scrape or
touch the transducers with sharp objects. Any impact on the wind sensor
array damages the device.