CAP. 2 - GENERAL INSTRUCTIONS 4 / 74 ENGLISH
ClimFill Maxi
CAP. 2 - GENERAL INSTRUCTIONS
2.1 GENERAL NOTES
All rights reserved.
This manual may not be reproduced, in part or entirely, either in printed or digital form.
It may be printed out solely for use by the user and operators of the equipment to
which it refers.
VALEO SERVICE and resources used for the drawing up of this manual will not be held
responsible for the incorrect use of the manual while they guarantee that information in
the manual have been duly checked.
The product can be subject to changes and improvements. VALEO SERVICE reserves
the right to change without notice the information contained in the manual.
2.2 GENERAL INSTRUCTIONS
Pressure equipment undergoes checks before commissioning and periodical checks
during operation in compliance with rules and law provisions in force in the country
where the equipment is used.
The operator is responsible for operating the equipment in conformity with local
legislation.
The equipment is designed for recovering and recycling R134a refrigerant fluid from
A/C systems of buses, cars and similar vehicles.
The equipment is intended to be used by repair and service garages for buses, cars
and similar vehicles.
This equipment is intended solely for use by professionally trained operators familiar with
the basics of refrigeration, refrigeration systems, refrigerants and the hazards associated
with pressurised equipment.
Careful reading of the present manual by the owners, the users and the operators is
required for a correct and safe use of the equipment.
The user shall not be entitled to open the product since maintenance operations are
reserved to the authorised service centre.
2.3 MANUFACTURER IDENTIFICATION
The ClimFill
®
Maxi equipment is manufactured by:
VALEO SERVICE
70 rue Pleyel Cedex
93285 Saint Denis (France)
To Next Page
Loading...