CAP. 8 - COMMISSIONING 34 / 74 ENGLISH
ClimFill Maxi
CAP. 8 - COMMISSIONING
8.1 CONNECTIONS
The product has to be positioned on a horizontal surface to ensure the correct
operation.
The unit has to be connected to the electric mains following instructions on the
identification plate of the product applied next to the main switch, mainly as to
applicable voltage and power.
8.2 Positioning and electric connections
HANDLING: During handling, the personal protective equipment (safety
shoes and protective gloves) required for correct handling shall be
ensured, as provided for by accident prevention provisions.
POSITIONING: Place the unit in a stable place. The location must be well
ventilated, with a good rate of change of air. The unit must be located
at least 10 cm from any object that could obstruct internal ventilation.
Keep the unit away from rain and excessive humidity as they can
irreparably damage it. In addition, the equipment must never be
directly exposed to sunrays or to excessive dust.
INSTALLATION: The installation shall be carried out by specialized
personnel, strictly complying with the instructions contained in this
manual. The use of the equipment in explosive atmosphere is forbidden.
CONNECTIONS: since the unit is connected to the mains power supply, it
must be properly grounded with its power plug GND pin. Failure to
ground the unit can damage it and constitutes a risk of fatal injury to the
operator. Position the unit so that the power plug is easy for the operator
to access.
To Next Page
Loading...