ENGLISH 55 / 74 CAP. 13 - MAINTENANCE
ClimFill Maxi
13.3 DRYER FILTER CHANGE
The software will notify when the dryer filer of ClimFill
®
Maxi must be replaced (see Chap.
13.3.2).
To replace the filters, select FILTERS REPLACEMENT from the MAINTENANCE Menu and press
on the display. (For the touchscreen use, see chap. 5.8)
Equipment:
• 1 Medium-sized cross-tip screwdriver
• 1 Hex key (24 mm)
• 1 Hex key (17 mm)
• 1 Hex torque key (24 mm)
For replacement, comply with the instructions outlined below:
1. disconnect the HP and LP hoses from other systems/circuits or vehicles and close
the quick couplers
2. the unit turns on and empties the hoses.
3. Confirm to have already worn the personal protective equipment (PPE) and follow
the safety regulations in force.
DANGER OF CONTACT WITH R134a REFRIGERANT and motor vehicle A/C system oil
4. Before opening the doors of the equipment, switch off the disconnector and
disconnect the machine from the power supply.
DANGEROUS VOLTAGE HAZARD
Circuit breaker Position of the connection cable to the
mains.
To Next Page
Loading...