VAMP 59 - Configuring Digital Inputs DI; Configuring Digital Outputs DO

Operation and configuration
2 Local panel user interface
2.4 Configuration and parameter
setting
VM59.EN001
VAMP 24h support phone +358 (0)20 753 3264
29
Available links:
 DO, DI
 IL
 I2/In, I2/I1, I2, I1, IoCalc
 f
 Io
 IoRMS
 IL3, IL2, IL1
 IL1Rem, IL2Rem, IL3Rem
 THDIL1, THDIL2, THDIL3
 IL1RMS, IL2RMS, IL3RMS
 ILmin
 ILmax
 T
 Uo
2.4.4. Configuring digital inputs DI
The following functions can be read and set via the submenus
of the digital inputs menu:
 The status of digital inputs (DIGITAL INPUTS 1,2)
 Operation counters (DI COUNTERS)
 Operation delay (DELAYs for DigIn)
 The polarity of the input signal (INPUT POLARITY). Either
normal open (NO) or normal closed (NC) circuit.
 Event enabling EVENT MASK1
2.4.5. Configuring digital outputs DO
The following functions can be read and set via the submenus
of the digital outputs menu:
 The status of the output relays (RELAY OUTPUTS1 and 2)
 The forcing of the output relays (RELAY OUTPUTS1 and 2)
(only if Force = ON):
o Forced control (0 or 1) of the Trip relays
o Forced control (0 or 1) of the Alarm relays
o Forced control (0 or 1) of the IF relay
 The configuration of the output signals to the output relays.
The configuration of the operation indicators (LED) Alarm
and Trip and application specific alarm leds A, B, C, D, E, F,
G and H (that is, the output relay matrix).
NOTE! The amount of Trip and Alarm relays depends on the relay
type and optional hardware.