VAMP 59 - Page 34

2.4 Configuration and parameter
setting
2 Local panel user interface
Operation and configuration
34
VAMP 24h support phone +358 (0)20 753 3264
VM59.EN001
EXTERNAL I/O PROTOCOL
External I/O is actually a set of protocols which are designed to
be used with the extension I/O modules connected to the
extension port. Only one instance of this protocol is possible.
Selectable protocols:
 Modbus: This is a modbus master protocol.
Bit rate [bit/s]. Default is ”9600”.
Parity [Parity]. Default is ”Even”.
 RTDInput: This protocol is designed to be used together
with VIO 12A RTD input module.
Bit rate [bit/s]. Default is ”9600”.
Parity [Parity]. Default is ”Even”.
For details see the technical desctiption part of the manual.
DNP3
Only one instance of this protocol is possible.
 Bit rate [bit/s]. Default is "9600".
 [Parity].
 Address for this device [SlvAddr]. This address has to be
unique within the system.
 Master's address [MstrAddr].
For further details see the technical description part of the
manual.
IEC 60870-5-101
 Bit rate [bit/s]. Default is “9600”.
 [Parity].
 Link layer address for this device [LLAddr].
 ASDU address [ALAddr].
For further details see the technical description part of the
manual.