Vatech A9 Technical Manual

Vatech A9 (PHT-30CSS)
Technical manual
VDH-TeM-098
194 / 214
COPYRIGHT© 2020 VATECH.
ALL RIGHTS RESERVED
Command Remark
[SPM_TEST_xxxx] Commands for test purposes such as Input/Output Check
and Motor Aging test
[SPM_FISS_xxxx] Command to set CT sensor sensitivity and binning mode
(FISS) and to read its value (FISR)
0000: High Gain, 2x2 Binning
0001: High Gain, 4x4 Binning
0002: Low Gain, 2x2 Binning (Default when equipment
power On/Off and not saved.)
0003: Low Gain, 4x4 Binning
[SPM_FISR] X-axis Stop Torque Value Setting
[SPM_FISM_x] Sensor sync signal mode
0 : Internal Sync
1 : External Sync
[SPM_FIPM_x] Sensor size setting = x (x= 0~32)
[SPM_MAGI] Manufacturing Aging Test start command (all motors run, but
not for bib up/down motors)
[SPM_MAG?] Request Manufacturing Aging Test Count Value
[SPM_MAGE] Manufacturing Aging Test End Command
[SPM_MATS_xxxx] Aging test time setting (0001: 1 minute)
[SPM_MAT?] Request Manufacturing Aging Test Time Setting Value
[SPM_RINT]
The set parameter value is initialized and the value of the
saved parameter is returned to the default value.
When initialized, the existing [spm_pver] value is viewed and
re-entered, mp3 language setting initialization is domestic.
No sound when voice is changed by mode.
Easy to modify when saving the existing parameter value.
[SPM_XFTA_0000] Setting the CEPH Sensor Axis Motor FRONTAL Start
Position in CEPH Mode
[SPM_XFT?]
Requesting CEPH sensor axis motor FRONTAL starting
position value in CEPH mode
[SPM_XLTA_0000] Setting the CEPH Sensor Axis Motor LATERAL Start Position
in CEPH Mode
[SPM_XLT?] Requesting CEPH sensor axis motor LATERAL starting
position value in CEPH mode
[SPM_POFS_00000]
Saving the recording rotator start position offset value in
PANO mode (1st clockwise is "1, clockwise if 0")
[SPM_PO?_] Requesting the image rotator start position offset value in
PANO mode
[SPM_COFS_00000]
Saving the recording rotator start position offset value in
ARCT mode (1st clockwise is "1, clockwise if 0")
[SPM_CO?_] Requesting the image rotator start position offset value in
ARCT mode
[SPM_FOFS_00000] Saving the recording rotator start position offset value in
FAST PANO mode (1st clockwise is "1, clockwise if 0")

Vatech A9 Specifications

General

Brand	Vatech
Model	A9
Category	Medical Equipment
Language	English