Run 9
________________________________________________________________________________________
_______________________________________
9-65
9.3.5 Advanced Controls: 360 Panel
These settings are:
Auto Length Cut When “ON”, the distance travelled in a non-360 degree (open) panel
is controlled by Auto Cut L1 for the left field, and Auto Cut R1 for the
right field. See section 9.3
Autocut L1 Distance travelled before automatically stopping and end trimming.
Can be set by entering distance value in to screen, or by setting large
number 9999 and then pressing End Cycle at appropriate time. This
saves the correct distance. Refer 9.1.8.2
Autocut R1 As for Autocut L1 but applies to RIGHT working field. Refer 9.1.8.2
Non-360 feed tape Pre-feed distance for band on non-360 panel. This is the distance the
band feeds during the z-lower. It should be set so that it does not
quite reach the tape present switch.
Enable EndPODS Turning this on enables the AutoTrim EndPOD manifolds. Thus on a
non-360 panel, if the endpods are connected they will operate in the
field which they are connected. Refer separate endpod operating
manual.
To Next Page
Loading...