Start Up 8
________________________________________________________________________________________
_______________________________________
8-3
• Clear all error messages by pushing the screen RESET
button (828).
The machine is now ready to start.
If starting from power up, a General Set will be required to set the axes (refer 8.2 General Reset).
If re-starting after an Emergency Stop Error the machine is now ready to run (no General Reset
Required.
Ensure that all axis movements are free from obstruction prior to performing a general set
so as to avoid the possibility of damage.
8.1.2 Switching off
• Ensure the machine is stopped and in it’s park posit
ion with the Aggregate in it’s up position.
• Switch off the Vacuum Pump selector switch (817).
• Press the Emergency Stop Pushbutton (823) or Pull Wire (806)
• Shut down the PC screen using the ON/OFF (818) on the front of the console.
• When the screen has shut down, switch off the machine isolator (801)
• Turn off the power supply to the machine at the wall and release air pressure.
The pneumatic system is not depressurised when the electrical systems are turned off.
CAUTION !
CAUTION !
830
809
801
To Next Page
Loading...