Run 9
________________________________________________________________________________________
_______________________________________
9-15
9.1.6 Setting the Glue Nozzle Wiper
A pneumatically operated wiper (20) passes a blade across the nozzle after each cycle
and prior to the start of a new cycle. This is to remove any residual glue which could get
on the front edge of the tape as it passes the nozzle and also serves to keep the nozzle
free of burnt glue.
IMPORTANT!
The nozzle wiper plays a very important part in the consistency of butt joins.
Make sure this wiper is kept clean and adjusted so that it removes all glue from the
face of the nozzle such that when the edging material passes over the nozzle and
lays on the panel, it is completely free of glue.
The nozzle wiper should be checked regularly for build up of glue and cleaned as
necessary. This can simply be achieved by removing the tape presser pin (see tape
presser in previous section 9.1.4). It is then a simple matter to access the wiper blade for
cleaning.
The nozzle wiper can be manually operated from the Functions page .
From the home page, touch the Functions icon (989)
920
988
989
To Next Page
Loading...