Assembly 5
________________________________________________________________________________________
_______________________________________
5-1
Assembly
5.1 General Instructions
We strongly recommend that you have assembly work on this machine/unit (for
example after spare part delivery) performed by authorised and qualified after-sales
service personnel. We cannot accept any liability for damage resulting from
incorrect action.
The Vector Revolution 180 contour edgebander machine is usually supplied partially
disassembled. This is to facilitate fitting the machine into the transport container.
5.2
Machine Assembly
5.2.1 Re-fitting of components removed for transportation
The following items are removed for the purpose of transporting the machine in a
container. This is due to the limitations in width of the container. In the event that
the machine is to be transported in such a way that the width limitations of a
container are not present, it is not necessary to remove any of these components.
• X Axis Drive Motor
• X Axis Cable Chain and support
• Rear X Axis drive belt fixing
• X Axis counter
• X Axis Positive and Negative Limit Switches.
• Emergency Stop Pullwire
• Tape coil support
• Front and rear Y-Arm Covers
Re-assembly of these is as follows:
5.2.1.1 X Axis Drive Motor
The X axis drive motor is removed for transportation. It consists of the drive motor
(10), mounting plate (11), belt wipers (12) and drive (13) and idler pulleys (14).
10
11
12
13
14
To Next Page
Loading...