Run 9
________________________________________________________________________________________
_______________________________________
9-84
Available functions are:
926 Glue On Off
994 Tape Feed Starts feed rollers. If Glue is turned on, tape will feed and
apply glue to band.
950 Roller 3 Fwd Swings third roller forward to allow access to glue unit
990 Tape Change Brings head to front of machine and rotates C axis into
tape load position
940 Nozzle Wiper Pushes nozzle wiper out provided temperature > 150 degC
941 Extractor Turns on shavings extractor fan
942 Blower Activates air blower (optional)
976 Trim Vertical Brings the trimmer unit together
992 Saw Mode Performs an end trim function.
943 Join Sensor Arm Swings the join sensor arm out for ease of adjustment
951 Purge Glue Purges glue through the nozzle provided at set temp
946 Auto EndTrim L Manual operation of the Left Field Endtrim manifold
947 Auto EndTrim R Manual operation of the Right Field Endtrim Manifold
All of the above functions automatically reset to their normal state (except glue) when
exiting the functions page.
944 Comb Element Display of actual temperature
945 Nozzle Element Display of actual temperature
970 Load/Save Access to the Load/Save page. Refer 9.6
971 General Set Zero set for X, Y and C axes when first powering machine.
Refer Manual section 8.2 General Set
972 Exit Runtime Press and hold for 2 seconds to exit the Machine runtime and
go back to the Windows Desktop
Double Click the Vijeo Runtime icon on the desktop to return to
the Machine Runtime screen.
To Next Page
Loading...