Transport, offloading, setting up 4
________________________________________________________________________________________
_______________________________________
4/4
The centre of gravity of the machine is at the outer end of the machine. Keep
supported at all times.
It is preferable to jack the machine up onto suitable rolling skates to facilitate easy
removal from the container.
The machine guide bars (1) will serve to keep the machine aligned as it is
pulled from the container.
The machine can now be pulled further from the container until such time as
the lifting points (3) are revealed. At this point, if a crane is being used, a
second set of strops can be affixed enabling the entire machine to be lifted
facilitating easy removal of the machine from the container.
When the machine is sufficiently removed from the container, it is recommended that
it is lowered onto rolling elements or alternatively supported while crane strops are
fixed under the outer lifting points (2).
Make sure that the machine does not tilt!
When lifting by crane, it is recommended to use 4 equal length fabric strops
which should be looped through the frame in the four points indicated (2) and
CAUTION !
DANGER !
2
5
3
6 7
To Next Page
Loading...